Install fauxcloud
Write fauxcloud to your ESP32 board from this page, over USB. It takes about a minute, and there is nothing to install on your computer besides, sometimes, a USB driver.
This installer needs Chrome or Edge on a computer. It talks to the board through Web Serial, which phones, tablets, Safari and Firefox do not have. Elsewhere, flash it by hand with esptool.
Open this page in Chrome or Edge on a Windows, macOS or Linux computer, or flash it by hand with esptool.
Loading the list of boards…
Unticked, the installer writes the four parts of fauxcloud and nothing else, so a board that already runs fauxcloud keeps its Wi-Fi, keys and learned values. It reads the board's flash layout first: if it differs from this version's, the installer stops and asks for this box.
Flashing log
Next: set it up
Unplug the board, wait 30 seconds and plug it in again, then go on with step 2. Some boards bring their Wi-Fi up only after this power cut. No Wi-Fi?
Join the Wi-Fi
fauxcloud-setup-XXXXwith the passwordfauxcloud: scan the QR code above with your phone, or pick it from the list.XXXX is the end of the board's own address; the Wi-Fi list shows the full name.
Open
http://fauxcloud.setupin the phone's browser.
Free software under GPL-3.0-or-later, provided as is, without warranty of any kind; you flash and run it at your own risk. The installer runs in your browser with esptool-js, pako and atob-lite (Apache-2.0; MIT and Zlib; MIT) and sends nothing anywhere.
fauxcloud is an independent project, not affiliated with or endorsed by Espressif or any weather station maker.